Installation Guide
Abstract
This document describes how to install the software for SMO O1, it’s dependencies and required system resources.
Version history
Date |
Ver. |
Author |
Comment |
2021-12-13 |
0.0.1 |
Initial Version |
|
0.0.2 |
|||
1.0 |
Introduction
O1:
This document describes the supported software and hardware configurations for the reference component as well as providing guidelines on how to install and configure such reference system.
The audience of this document is assumed to have good knowledge in RAN network, Docker and Linux system.
Preface
Prerequisites:
Before starting the installation of O1, make sure the following hardware and software requirements are met.
Hardware Requirements
System:
Following minimum hardware requirements must be met for installation of SMO O1. While the system can be installed on a smaller system, it will be slow, and difficult to use:
HW Aspect |
Requirement |
# of servers |
1 |
CPU |
4 |
RAM |
16G |
Disk |
100G |
NICs |
1 |
Software Installation and Deployment
Docker and docker-compose:
This section describes the installation of the software to enable the SMO O1 interface on the referenced hardware.
The software installation has been tested on a Ubuntu 20.04 based system. Assuming such an installation, make sure that Docker and docker-compose are installed on the system.
To deploy the solution, type the following on the command line:
$ docker-compose up -d
Once the deployment is successful, verify the deployment using the following command:
$ docker-compose ps
Expect an output that is similar to this:
Name Command State Ports
------------------------------------------------------------------------------------------------------------------------------------
sdnr /bin/sh -c /opt/onap/sdnc/ ... Up 0.0.0.0:8101->8101/tcp,:::8101->8101/tcp, 0.0.0.0:8181->8181/tcp,:::8181->8181/tcp
sdnrdb /tini -- /usr/local/bin/do ... Up 9200/tcp, 9300/tcp
Thereafter, the GUI interface for O1 can be accessed at:
http://<host_ip>:8181/odlux/index.html
The username/password is:
admin/Kp8bJ4SXszM0WXlhak3eHlcse2gAw84vaoGGmJvUy2U
and can be updated by updating the .env file in the repository.