Installation Guide

Abstract

This document describes how to install the software for SMO O2, it’s dependencies and required system resources.

Version history

Date

Ver.

Author

Comment

20XX-XX-XX

0.1.0

First draft

0.1.1

1.0

Introduction

This document describes the supported software and hardware configurations for the reference component as well as providing guidelines on how to install and configure such reference system.

The audience of this document is assumed to have good knowledge in RAN network nd Linux system.

Preface

Tacker Preface

Before starting the installation of Tacker, make sure git is installed on the system.

Hardware Requirements

Tacker Hardware Requirements

Following minimum hardware requirements must be met for installation of Tacker:

HW Aspect

Requirement

# of servers

1

CPU

4

RAM

16G

Disk

80G

NICs

1

Software Installation and Deployment

Tacker Installation

This section describes the installation of the Tacker installation on the reference hardware.

  • Installation Using Install Script

    The install script can be retrieved from smo-o2 repository:

    $ git clone https://gerrit.o-ran-sc.org/r/smo/o2
    

    Usage:

    $ cd o2/tacker/scripts
    $ ./install.sh <HOST_IP>
    
    <HOST_IP>: You should set host IP for API endpoint of Tacker.
    

    This script installs the Tacker via Devstack (Standalone mode). It uses the latest repositories (Devstack and Tacker).

    If you want to use other version, you have to change the URL.

    e.g.:

    git clone https://opendev.org/openstack-dev/devstack -b stable/yoga
    wget https://opendev.org/openstack/tacker/raw/branch/stable/yoga/devstack/local.conf.standalone
    
  • Manual Installation

    See the following documents.

References